X-831-070 A/B

Product Description

Shin-Etsu's X-831-070 A/B is a dual component, room-temperature or heat accelerated cure, self-leveling potting encapsulant that will cure to form a durable, flexible rubber to protect electronic components. X-831-070 A/B exhibits excellent electrical isolation and adhesion to printed circuit board substrates, metals, plastics, glass, and ceramics.

Product Features

  • Dual component
  • Room temperature or heat accelerated cure
  • Self-leveling

Typical Applications

  • Protecting and electrically isolating electronic components
  • Stress reduction

Typical Properties

Type
Potting Encapsulant
Cure Type
Addition
One/Two Component
Two
Color
Black
Density @ 23C (g/cm3)
1.23
Viscosity A (cps)
15000
Mix Ratio by weight
100:100
Cure Conditions
24hr @ 23C
Snap Time (min)
6
Shore A Hardness
30
Tensile Strength (MPa)
1.20
Tear Strength (kN/m)
4
% Elongation
125
Volume Resistivity (TΩ·m)
4.5
Dielectric Strength (kV/mm)
22
Dielectric Constant
3.7 @ 50Hz
Dielectric Dissipation Factor
3.5x10-2 @ 50Hz
Usable Temperature Range (C)
-40 to +180

Note: Values are not for specification purposes.

Warranty- The information and data contained herein are believed to be accurate and reliable; however it is the user's responsibility to determine suitability of use. Since Shin-Etsu Silicones, Inc. cannot know all of the uses to which its products may be put or the conditions of use, it makes no warranties concerning the fitness or suitability of its products for a particular use or purpose. You should thoroughly test any proposed use of our products and independently conclude satisfactory performance in your application. Likewise, if the manner in which our products are used requires governmental approval or clearance, you must obtain it. Shin-Etsu Silicones, Inc. warrants only that its products will meet its specifications. There is no warranty of merchantability of fitness of use, nor any other expressed or implied warranties. The user's exclusive remedy and Shin-Etsu Silicones, Inc.'s sole liability is limited to refund of the price or replacement of any product shown to be otherwise than as warranted. Shin-Etsu Silicones, Inc. will not be liable for incidental or consequential damages of any kind. Suggestions of uses should not be taken as inducements to infringe any patents.

Contact Us
Shin-Etsu Silicones of America, Inc.
1150 Damar Drive
Akron, Ohio 44305-1201

You can leave a message using the contact form here.

Please Note - This is for general business and product inquiries only! Messages sent using this form will be received by our inside sales dapartment.

If you are inquiring about employment opportunities please use the corresponding link that is listed with the post in our Jobs Listings section of our site.