SDP-3540 A/B

Product Features

  • Superior thermal conductivity
  • Excellent electrical properties
  • UL-94 V-0 equivalent flame rating
  • Superior reworkability

Typical Applications

  • Electronics applications requiring thermal dissipation

Typical Properties

Type
Liquid-dispensed Gap Filling Rubber
Cure Type
Addition
One/Two Component
Two
Low Molecular Weight Siloxane Stripped?
Y
Color
Gray
Density @ 23C (g/cm3)
3.08
Viscosity (Pa·s)
89
Mix Ratio by Weight
100:100
Cure Conditions
24hr @ 25C
Tack Free Time (min)
360
Working Time
4 Hours
Shore 00 Hardness
44
Tensile Strength (MPa)
0.10
% Elongation
40
Volume Resistivity (TΩ·m)
1.800
Dielectric Strength (kV/mm)
20.0
Dielectric Dissipation Factor
4 x 10-3 @ 50Hz
Dielectric Constant
6.0 @ 50Hz
Thermal Conductivity (W/m·K)
3.50
Thermal Resistance (mm2·K/W)
37
Usable Temp. Range (C)
-40 to +180
Bond Line Thickness (μm)
120

Note: Values are not for specification purposes.

Warranty- The information and data contained herein are believed to be accurate and reliable; however it is the user's responsibility to determine suitability of use. Since Shin-Etsu Silicones, Inc. cannot know all of the uses to which its products may be put or the conditions of use, it makes no warranties concerning the fitness or suitability of its products for a particular use or purpose. You should thoroughly test any proposed use of our products and independently conclude satisfactory performance in your application. Likewise, if the manner in which our products are used requires governmental approval or clearance, you must obtain it. Shin-Etsu Silicones, Inc. warrants only that its products will meet its specifications. There is no warranty of merchantability of fitness of use, nor any other expressed or implied warranties. The user's exclusive remedy and Shin-Etsu Silicones, Inc.'s sole liability is limited to refund of the price or replacement of any product shown to be otherwise than as warranted. Shin-Etsu Silicones, Inc. will not be liable for incidental or consequential damages of any kind. Suggestions of uses should not be taken as inducements to infringe any patents.

Contact Us
Shin-Etsu Silicones of America, Inc.
1150 Damar Drive
Akron, Ohio 44305-1201

You can leave a message using the contact form here.

Please Note - This is for general business and product inquiries only! Messages sent using this form will be received by our inside sales dapartment.

If you are inquiring about employment opportunities please use the corresponding link that is listed with the post in our Jobs Listings section of our site.